If you’re using a guitar amp, and not just the pedals, you’ll obviously need to mic your amp, and that microphone will have to go back into the mic pre on your interface. Check your reamp box and obviously your I/Os as to which ones you need.” Pedals and Amps “It’s either going to be an XLR cable to an XLR cable, an XLR to a stereo balanced ¼-inch, or a balanced 1/4-inch output to a balanced ¼-inch input. “Make sure that you match your inputs and outputs correctly, and remember that balanced line signals are three pins, not two,” Huart says. “If your output is a balanced line from an XLR, you’re going to have to get an XLR-balanced cable and make that go to a ¼-inch balanced cable on most of these reamp boxes.” Some reamp boxes do take XLR in, and if that is the case, it will make life easier, however, some more affordable ones have only ¼-inch inputs. “Many interfaces, especially on at the ‘prosumer’ level, are going to have a ¼-inch instrument input,” Huart says. Start by reviewing and understanding the inputs and outputs of your interface and be certain that you have all of the right cables. “It gives you another palette, a selection of organic analog equipment, that you can use,” Huart says. You can then use all of your guitar pedals as your front end and put that back into a guitar amp or directly back into your DAW (digital audio workstation).”įor example, his colleague Bob Horn, engineer/producer for Usher, Nelly, Everclear and Timbaland, uses guitar pedals on his mixes and not just for guitars, but for vocals, keyboards, drum loops or anything. “That goes through the reamp into your normal guitar chain. “This allows you to send a direct clean signal off of your computer,” Huart says. How Reamp Boxes WorkĪll reamps take a balanced line-level signal from either a mixer or an interface and make it into an unbalanced instrument-level signal that can be handled by a guitar amp. In this tutorial, Warren Huart explains reamping and how to get the best results in the most practical ways. For the guitarist on a budget, Saturnworks, Switchcraft and Radial offer affordable options. If you want to reamp, you’ll find plenty of reamp boxes on the market, including some that won’t empty your wallet. “Printing a DI gives you a lot of flexibility when it comes to mixing, especially if you don’t mix your own stuff and you give it to somebody who wants to dramatically change your guitar sounds to fit their vision of how your song should be mixed,” Huart says.
0 Comments
Leave a Reply. |